DIRT BIKE

Part Description: Precision, high-quality main bearing and seal kits complement installation of Hot Rods crankshaft assemblies Quality alternative to expensive OEM bearings and seals

Part Description: Improves heat dissipation Stronger than stock Precision machined from billet T-6 aircraft-quality aluminum Race proven by virtually every factory race team Hard-coated to resist boot wear Made in the USA

Part Description: Engine crankcase coating against wear, shocks, abrasions due to contact with boots, mud, sand and debris Right side: clutch cover protection, water pump and lower crankcase Left side: ignition cover and clutch actuator protection Applies with the original screws adhering perfectly to the clutch/ignition crankcase Resistant to high temperatures Compatible with Acerbis skid plates. Design studied not to interfere with the boot

Part Description: Engine crankcase coating against wear, shocks, abrasions due to contact with boots, mud, sand and debris Right side: clutch cover protection, water pump and lower crankcase Left side: ignition cover and clutch actuator protection Applies with the original screws adhering perfectly to the clutch/ignition crankcase Resistant to high temperatures Compatible with Acerbis skid plates. Design studied not to interfere with the boots.

Part Description: Kit includes: pump, filter, hoses, clamps, wiring harness and filter if needed Kit includes all necessary parts to rebuild the OEM fuel pump module Restores lost performance or non-functioning fuel pump with this economical solution Kit comes ready for plug and play installation

Part Description: Drop-in replacement fuel pump module including the housing - with a new fuel pump, strainer fuel lines, retainer, wire harness, gasket and hardware as required. Economical solution for restoring lost performance or non-performing fuel pump. Pump draw less current than OEM pump while maintaining the same flow rate and working pressure reducing working temperatures and increasing unit life